Additional Nexus reference PDFs:

Nexus legacy documentation:

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Normally, the force plate origin is chosen by placing the calibration device on the desired corner of the force plate. In this case, the position offset is half the width and half the length of the plate. However, for other plates that did not have the calibration device placed on them during calibration, you must fully specify the coordinates of the center of the plate in relation to the capture volume origin.

Scroll Pagebreak

Orientation section

Scroll Table Layout
sortDirectionASC
repeatTableHeadersdefault
style
widths20%, 80%
sortByColumn1
sortEnabledfalse
cellHighlightingtrue

...